Blog · 2026-10-25
Can I install a water softener myself? Wichita and Sedgwick County rules
Homeowners who live in the house can do it with a permit. The rules by town, what the job involves and when a plumber makes more sense.

Yes, if you own and live in the home, but it is permit work, not a quick swap. In Wichita and unincorporated Sedgwick County, MABCD says a homeowner doing their own trade work needs a permit and must either pass the county's homeowner exam for that trade or name a licensed sub-contractor, and Goddard, Maize, Cheney, Derby and Andover each start permits at their own city office. With Jackrabbit, a licensed local plumber installs the system and gets any required permit under their own license.
This post covers the permit rules by town, what the install involves, and when hiring a plumber makes more sense.
Do you need a permit in Wichita and Sedgwick County?
The Metropolitan Area Building and Construction Department (MABCD) handles permits for the City of Wichita and unincorporated Sedgwick County. Its Do I Need a Permit? page sets out the homeowner rules. The first one is plain: "You must own and occupy the home. If you own the home but do not live in the home, you MUST use a licensed contractor to do the work." So a landlord cannot use the homeowner route on a rental.
When you apply, MABCD says you either name a licensed sub-contractor for each trade on the job or schedule the homeowner exam for each trade you plan to do yourself. You also file a Homeowner Declaration Form. After the permit is issued, you schedule and pass the inspections.
The Wichita and Sedgwick County Unified Building and Trade Code, linked from that MABCD page, backs this up. Section 3.1.440 lets an owner-occupant of a detached single-family home install plumbing if they do all the labor, submit a plan of the installation and pass an open-book exam first. Section 3.1.420 lists installing "water heating or treating equipment" without the proper permit among the grounds for action against a licensed trade. The code also treats water conditioning as a licensed trade of its own.
MABCD's pages do not name water softeners, so call 316-660-1840 before you start. Ask whether your job, including a straight swap of an old unit, needs a plumbing permit.
The homeowner plumbing exam
MABCD lists a homeowner plumbing exam with multiple-choice questions, open book, based on the Uniform Plumbing Code book. You need 75% to pass, the exam has no time limit, and it must be started before 1 p.m. If you choose to test, MABCD issues the permit only after you pass. If you do not pass, a licensed sub-contractor has to do that part of the work.
MABCD also lists separate water heater and electrical exams. Which exam a softener-only job calls for is something to ask MABCD at 316-660-1840 when you call about the permit.
Goddard, Maize, Cheney, Derby and Andover
Sedgwick County's small-cities page says the permitting process "will always start with the small city," even where MABCD does inspections for that city. MABCD's online permit portal is for Wichita and unincorporated Sedgwick County only.
| Where you live | Who you call | Number |
|---|---|---|
| Wichita, unincorporated Sedgwick County | MABCD | 316-660-1840 |
| Goddard | Goddard Community Development | 316-794-2441 |
| Maize | Maize Administration | 316-722-7561 |
| Cheney | Cheney Building Permit Information | 316-540-3622 |
| Derby | Derby Building Trades & Inspections | 316-788-6632 |
| Andover | Andover Building Department | (316) 733-1303 ext. 422 |
Derby runs its own permitting, licensing and inspections. Andover, in Butler County, has its own building department, and its plumbing permit application lists "Water Conditioning" as a line item and says permit approval is required before starting any work. Whether a homeowner can pull the permit and which exam applies is different in each of these cities, so ask your city office. If you live outside city limits near any of these towns, start with MABCD.
Local guides: Goddard, Andover, Derby.
What installing a softener actually involves
This is a description of the job, not step-by-step instructions.
- Water off, main line opened. The softener ties into the main line where water enters the house, or into a softener loop if the house has one. Many newer homes have a loop. Older ones often do not.
- Bypass valve. A bypass lets you run unsoftened water while the unit is serviced or out of salt.
- Which lines get softened. Outdoor hose bibs are often left on hard water, and some owners keep a cold line at the kitchen. A kitchen RO system goes at the kitchen sink.
- Drain line and overflow. The control valve needs a drain line to a floor drain, standpipe or laundry drain with an air gap, and the brine tank has an overflow. Penn State Extension estimates about 50 gallons go to drain per regeneration, which adds load if your home is on a septic system.
- Power. The control valve needs an outlet nearby. Whether adding one needs its own electrical permit is a question for MABCD or your city.
- Backflow in Andover. Andover's amendments to its city plumbing code allow water-operated equipment only with an approved backflow prevention device.
- Startup. Set the hardness from your utility's report (our FAQ explains grains per gallon), add salt and set the regeneration time.
- Inspection. If the job needs a permit, it needs an inspection, and you schedule it.
For sizing the unit before you buy, see what size water softener a Wichita home needs.
When a plumber is the better choice
Plenty of homeowners do their own plumbing. A plumber makes more sense in some cases:
- You rent the house out or do not live in it. MABCD requires a licensed contractor then.
- There is no softener loop and the main line is hard to reach.
- The house has old galvanized or mixed pipe.
- There is no drain near where the softener would sit.
- You are on a private well that may need iron or sulfur treatment first. See our Goddard well water page and city vs well water.
- You would rather not take the exam and schedule inspections.
How it works with Jackrabbit
Jackrabbit sells whole-home softener and carbon filtration systems and kitchen RO. A licensed local plumber installs the system, gets any required permit under their own license and starts it up. You make one payment to Jackrabbit for the equipment and installation. See how it works or the Wichita water softener page, or request a quote.
Questions about installing a softener yourself
Can I install a water softener myself in Wichita?
If you own and live in the home, MABCD lets you do your own trade work with a permit, after you pass the homeowner exam for that trade or name a licensed sub-contractor. Call MABCD at 316-660-1840 to confirm what your softener job needs.
Do I need a permit for a water softener in Sedgwick County?
The county code lists installing water treating equipment without the proper permit as a violation for licensed trades. MABCD's homeowner pages do not name softeners, so call 316-660-1840 to confirm.
I live in Goddard, Maize, Cheney, Derby or Andover. Who do I call?
Start with your city's building or community development office. Sedgwick County says permits in its small cities always start with the city, and Derby and Andover run their own departments.
Can a landlord install a softener in a rental?
Not as a homeowner permit. MABCD says that if you own the home but do not live in it, you must use a licensed contractor.
Who installs a Jackrabbit system?
A licensed local plumber installs it and gets any required permit under their own license. Jackrabbit sells the system and coordinates the install.
